HP LaserJet Managed MFP E82540-E82560 On-Site Installation Guide - Page 83

Table 8-2 2000-sheet HCI installation (continued) ❑ Locate and install two lift assist handles to the left side of the MFP. CAUTION: The device weighs 113.1 kg (249.3 lbs). ❑ Use four people to lift the device and carefully align on to the 2000-sheet HCI. ❑ Remove the lift assist handles. ❑ Remove the remaining tape and packing foam from the device. ❑ Remove the foam shipping block from the MP tray (Tray 1). ❑ Remove the packing materials from the trays and then remove the trays. ❑ Install the two thumbscrews to secure the MFP to the 2000-sheet HCI. ❑ Reinstall the trays. ❑ Remove the scanner lock screw and label and install the screw cover. ❑ Remove the protective film from the logo on the front door. ❑ Open the front door and install the toner cartridges. NOTE: Be sure to shake the toner cartridges vigorously (in the horizontal orientation) to loosen any compacted toner. ❑ Rotate the blue cross handle CCW until it pops off and then install the toner cartridge. Repeat for each toner cartridge. ❑ Pull straight OUT to remove the ITB cleaner seal. Verify the seal is not torn and no pieces are left attached to the ITB cleaner shutter. ❑ Pull straight OUT to remove seals on each developing unit. Verify the seals are not torn and no pieces are left attached to the developing unit shutters. ❑ Rotate each drum unit lock lever DOWN. ❑ Remove the drums from the foam packaging. NOTE: One drum unit is labeled K (black) and is unique for the black location. ❑ Push on each end of the orange drum cover to release it. ❑ Hold the drum unit with one hand on the bottom and one hand on the handle on the front of the drum unit. CAUTION: Don't use the toner waste pipe as a handle. ❑ Align the groove on the top of the drum unit to the guide at the top of the opening. ❑ Install the drum unit and then rotate the drum lock lever UP to secure the drum unit in position. ❑ Repeat these steps for the remaining drum units. NOTE: Be sure to install the drum unit labeled "K" in the black location. ❑ Rotate each toner supply shutter CCW to open. ❑ Verify EACH lock lever is UP and each toner supply shutter is OPEN. ❑ Install the TCU by pushing firmly on both ends and close the front door. ❑ Install the duplex turnaround guide with the barcode label facing up. TIP: Flex the guide and install the front and rear pins first and then slide up to snap the middle pin into position on the 2nd exit. ❑ Install the paper settling guides at two locations on the first exit. ❑ Perform Late Point Differentiation and Configuration (LPDC). ❑ Apply the "XA3" barcode inside the front door and nameplate on the outside. ENWW 2000-sheet HCI 77