HP LaserJet Managed MFP E82540-E82560 On-Site Installation Guide - Page 94

Table 8-9 On-site final setup job separator (continued) ❑ Pull OUT at the top to remove the left side of the power button cover. NOTE: A tab on the lower edge of the cover engages with a slot on the device. ❑ Snap off the upper left cover. ❑ Lift and pull out to remove the face-down bin (output bin). ❑ Remove the gray cover on the back wall under the scanner by removing four screws. NOTE: Two screws have stick-on covers. ❑ Unpack the Job Separator and locate the 2nd exit bin full assembly. ❑ Locate the pins on the rear and the three tabs along the length of the bin full sensor assembly. ❑ Locate the corresponding holes and slots on the 2nd exit assembly. ❑ Insert the tabs and slide the assembly toward the rear to fit the pins into the holes. ❑ Install one self-tapping screw at the front to secure the bin full sensor assembly. ❑ Connect the bin full sensor assembly cable to the device. ❑ Reinstall the gray cover, 4 screws and screw covers. ❑ Reinstall the left side of the power button cover. ❑ Reinstall the top output bin. ❑ Reinstall the upper left cover. ❑ Install the Job Separator by aligning the right edge to the 2nd exit area and the rear tab to the opening under the scanner. ❑ Install one screw to secure the Job Separator. Staples Click here to view a video of this procedure HP LaserJet Inner finisher and Booklet Maker finisher refill staple cartridge product number: Y1G13A. Replace the inner finisher staple cartridge 1. Open the staple cartridge access door. 88 Chapter 8 Complete installation procedures ENWW