HP LaserJet Managed MFP E82540-E82560 On-Site Installation Guide - Page 90

Table 8-6 On-site final setup inner finisher punch (continued) ❑ Remove the blue tape, close the dummy punch and close the front door. ❑ Place the finisher front side down on a table. ❑ Locate and remove three screws on the rear cover. ❑ Use a flat blade screwdriver to release the cover tab located at the lower rear corner near the cable entrance and lift the cover slightly. ❑ Now pull along the top edge to release three tabs and remove the cover. ❑ Locate the hinge pin at the rear of the dummy punch. ❑ Remove the e-clip at the bottom of the hinge pin and remove the hinge pin. ❑ Disconnect the cable. ❑ Turn the finisher back to its normal orientation.. ❑ Open the front cover. ❑ Open the dummy punch. ❑ Pull forward to remove the dummy punch from the inner finisher. ❑ Unpack the inner punch. ❑ Position the inner punch on the inner finisher and slide the cables through the chassis at the rear. ❑ Close the inner punch and the front cover. ❑ Place the inner finisher front side down on a table. ❑ Insert the hinge pin - verify cables are located to the left of the pin. ❑ Replace the e-clip. ❑ Connect the two cables. ❑ Replace the rear cover. TIP: Locate the three tabs along the top of the cover and engage with corresponding holes on the frame. ❑ Snap the cover back down in the lower corner. ❑ Reinstall three screws. ❑ Turn the finisher back to its normal orientation. ❑ Open the inner finisher front door. ❑ Unlatch and open the inner punch. ❑ Use a piece of blue tape to hold the latch in the open position. ❑ Place the black washer on the pin. ❑ Reinstall the e-clip on the pin. ❑ Peel off the backing and install the new mylar over the opening. ❑ Remove the dummy door and install the punch waste bin. ❑ Remove the blue tape and close the inner finisher. 84 Chapter 8 Complete installation procedures ENWW