HP LaserJet P2050 Service Manual - Page 170
Fuser, CAUTION,
View all HP LaserJet P2050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
Fuser CAUTION: The fuser might be hot. Allow enough time for the fuser to cool after the product power is turned off. NOTE: The cartridge-door assembly should be in the closed position when the fuser is removed to make sure that the fuser-drive gear is correctly aligned for reinstallation. 1. Remove the following components: ● Right cover. See Right cover on page 115. ● Left cover. See Left cover on page 118. ● Rear cover, rear door, and duplex-paper-feed assembly. See Rear cover, rear door, and duplex-paper-feed assembly on page 120. NOTE: Only the HP LaserJet P2050 Series products have a duplex-paper-feed assembly installed. ● Reverse-sensor assembly. See Reverse-sensor assembly; HP LaserJet P2050 Series on page 142. NOTE: Only the HP LaserJet P2050 Series products have a reverse-feed sensor installed. 2. Disconnect six connectors (callout 1), and then release the wire harnesses from the guide (callout 2). Figure 6-88 Remove the fuser (1 of 7) 2 1 158 Chapter 6 Removal and replacement ENWW