HP LaserJet P2050 Service Manual - Page 230

Alert message Load paper Manual feed No paper pickup Non-HP supply installed Not Connected Order black cartridge Page too complex Printing Description Recommended action The product did not detect paper in Tray 1 or 1. Tray 2. PS916 detects paper in Tray 1. PS914 detects paper in Tray 2. See Figure 7-7 Components in the print cartridge cavity 2. on page 199. Verify that paper is loaded in the input tray. Make sure that the photosensor flags are not hindered. 3. Make sure that connectors J205 (for Tray 1) and J204 (for Tray 2) on the engine controller PCA are seated. The product is set for manual feed mode. Load the correct paper into the tray, and then press the OK button to clear the message. The print engine has failed to pick up a piece Reload the paper in the input tray and press of paper. the OK button to continue the job. A new, non-HP supply has been installed. This message appears until an HP supply is installed or you press the OK button. If you believe you purchased an HP supply, go to www.hp.com/go/anticounterfeit. Service or repairs that are required as a result of using non-HP supplies are not covered under HP warranty. To continue printing, press the OK button. The product software cannot communicate with the product. 1. Make sure the product is turned on. 2. Make sure the USB cable is connected securely to the product and the computer. The identified print cartridge is nearing the end of its useful life. Order a new print cartridge. You can continue printing with the current print cartridge until redistributing the toner no longer yields acceptable print quality. The product cannot process the page. Press the OK button to continue printing the job, but output might be affected. The product is printing a document. Wait for printing to finish. 218 Chapter 7 Solve problems ENWW