HP LaserJet P2050 Service Manual - Page 237
Output bin full, Order black cartridge
View all HP LaserJet P2050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 237 highlights
Control-panel message Event code Load tray 1 Press [OK] for available media Manual duplex Load tray x Press [OK] Manual feed Press [OK] for available media Memory is low Press [OK] Misprint Press [OK] Non-HP supply installed Order black cartridge Ready Output bin full Remove all paper from bin Rear door open Remove shipping lock from black cartridge Description Recommended action No trays are configured for the Load the correct media into media type and size that the print tray 1, or press OK to use media job is requesting. in a different tray. The first side of a manual duplex job has printed, and the page needs to be loaded to process the second side. Load the page in the indicated tray with the side to be printed face up, and the top of the page away from you and then press OK. The product is set for manual feed mode. Press OK to clear the message or load the correct media into tray 1. The product memory is almost full. Press OK to finish the job, or press the Cancel button to cancel the job. For information about increasing the product memory, see Install memory (HP LaserJet P2050 Series Printers only) on page 64. Print media has been delayed as Press OK to clear the message. it moves through the product. A non-HP supply is installed. If you believe you purchased an HP supply, go to www.hp.com/ go/anticounterfeit. Service or repairs that are required as a result of using nonHP supplies are not covered under HP warranty. The print cartridge is nearing the end of its useful life. Order a new print cartridge. You can continue printing with the current print cartridge until redistributing the toner no longer yields acceptable print quality. See Parts and diagrams on page 253 for more information. As the output bin accumulates 1. paper, the output bin delivery flap rises until a flag blocks the photosensor (PS911). When the photosensor is blocked, this message appears. Rotate the output bin delivery flap up and down. The flap must move freely. If the top cover has been replaced, make sure that it has been installed correctly. 2. Make sure that the connector at J213 on the engine controller PCA are seated. Remove all paper from the bin. The product rear door is open. Close the door. A print cartridge shipping lock is Be sure that the print cartridge installed. shipping lock has been removed. ENWW Interpret control-panel messages (HP LaserJet P2050 Series Printers only) 225