HP LaserJet P2050 Service Manual - Page 40
Network config. menu (HP LaserJet P2055dn and HP LaserJet P2055x only) - laserjet p2055dn manual
View all HP LaserJet P2050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Network config. menu (HP LaserJet P2055dn and HP LaserJet P2055x only) Use this menu to establish network configuration settings. Menu item CFG TCP/IP Description Access the TCP/IP menu and set TCP/IP protocol parameters. BOOTP=YES* Enable IPv4 configuration by a BOOTP Server. DHCP=YES* Enable IPv4 configuration by a DHCP Server. (This item only displays on the control panel when BOOTP=NO*. If DHCP=YES* and the print server has a DHCP lease, you can configure the following DHCP settings: ● RELEASE: Select whether to release (YES) or save (NO) the current lease. ● RENEW: Select whether to renew (YES or NO) the lease. AUTO IP=YES* Automatically assign a link-local IPv4 address in the form 169.254.x.x. To manually set an IP, specify BOOTP=NO*, DHCP=NO* and AUTO IP=NO*, and then set the following TCP/IPv4 parameters from the control panel: Each byte of the IPv4 address (IP) Subnet Mask (SM) Syslog Server (LG) Default Gateway (GW) Idle Timeout period (default is 270 seconds, 0 disables the timeout) CFG DNS 1: IPv4 address of a primary DNS server (one byte at a time). CFG DNS 2: IPv4 address of a secondary DNS server (one byte at a time). IPV6 = YES*: Enable IPv6 operation. Select NO to disable IPv6 operation. POLICY=RTR_AV/RTR_UN/ALWAYS: Set one of the following IPv6 addressing policies: ● RTR_AV: (default) Stateful auto-configuration method is determined by a router. The router specifies whether the print server obtains its address, configuration information, or both from a DHCPv6 server. ● RTR_UN: Try to obtain stateful configuration from a DHCPv6 server (when a router is not available). ● ALWAYS: Always try to obtain stateful configuration from a DHCPv6 server (whether or not a router is available). MANUAL= KEEP/DISABLE: Set the behavior of a manually configured IPv6 address detected on the print server. ● KEEP (default): Maintain the address in an active state. ● DISABLE: Maintain the address, but in an inactive state. Print an HP Jetdirect configuration page to verify your settings. (The print server can overwrite selected parameters with values that ensure proper operation.) 28 Chapter 2 Control panel ENWW