HP SW TL881 DLT Mini-Lib/1 Compaq StorageWorks TL881/TL891 Family MiniLibrary - Page 111
Setting MiniLibrary Base Module (Slave) Configuration
![]() |
View all HP SW TL881 DLT Mini-Lib/1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
3-30 Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide Setting MiniLibrary Base Module (Slave) Configuration IMPORTANT: All MiniLibrary Base Modules are shipped configured as stand-alone systems. Before powering up the Expansion Unit in a MiniLibrary system for the first time, you must reconfigure each of the MiniLibrary Base Modules in the system as a slave. To do so, perform the following procedure on each MiniLibrary Base Module. 1. Turn on the power switch to the MiniLibrary Base Module. After a series of self-test screens, the following screen appears: DLT0 Idle DLT1 Idle Loader Idle 0 9 2. Press the Enter button to display the Main menu screen: Load/Unload Show Status Menu Maintenance Menu Configure Menu 3. Press the button three times to select the Configure menu, then press the Enter button. The following screen appears: Set Data Format Set SCSI Set Element Base Set Identification 4. Press the button repeatedly to select the Set Special Configuration screen: Set Serial Number Set Unload Mode Set Negotiation Set Special Config 5. Press the Enter button. The following screen appears: Mode Page 1F Length *Short 0x0E Model Number: *COMPAQ TL89x
![](/manual_guide/products/hewlettpackard-sw-tl881-dlt-minilib1-compaq-storageworks-tl881tl891-family-minilibrary-reference-guide-2000-0b2e4a1/111.png)