HP SW TL881 DLT Mini-Lib/1 Compaq StorageWorks TL881/TL891 Family MiniLibrary - Page 91
Installing the Belt, Insert a 0.050 in Allen wrench or a paper clip through
View all HP SW TL881 DLT Mini-Lib/1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
3-10 Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide Installing the Belt 1. Turn the assembled PTM over so that the motor points upward (see Figures 3-5 through 3-9). 2. Locate the tensioner ramp in the base section. Press the spring until the hole in the tensioner ramp is aligned with a hole in the base section (Figure 3-5). Insert a 0.050 in Allen wrench or a paper clip through the holes. This sets the idler pulley for zero belt tension. SHR-1705 Figure 3-5. Threading the belt through the base section 3. Locate the length of toothed belt that was enclosed with the extension section (Table 3-4).
3-10
Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide
Installing the Belt
1.
Turn the assembled PTM over so that the motor points upward (see
Figures 3-5 through 3-9).
2.
Locate the tensioner ramp in the base section. Press the spring until the
hole in the tensioner ramp is aligned with a hole in the base section
(Figure 3-5). Insert a 0.050 in Allen wrench or a paper clip through the
holes. This sets the idler pulley for zero belt tension.
SHR-1705
Figure 3-5.
Threading the belt through the base section
3.
Locate the length of toothed belt that was enclosed with the extension
section (Table 3-4).