HP SW TL881 DLT Mini-Lib/1 Compaq StorageWorks TL881/TL891 Family MiniLibrary - Page 97

3-16 Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide 6. Turn the PTM over and support it so that neither the motor nor the flange at the bottom of the base assembly is touching the work surface. 7. Remove the eight screws holding a pair of tie bars in place (Figures 3-1 and 3-4). Separate the PTM at that joint. You can now add sections as needed and install a new belt as described in the sections "Assembling the PTM" and "Installing the Belt." Mechanical Installation of the Expansion and MiniLibrary Base Modules The Expansion Unit and the MiniLibrary Base Module come with a set of Compaq inner rails installed. Note that the Compaq rackmount kit (P/N 968458-102) is packed with the module. The Expansion Unit and Base Module(s) can be rack-mounted in a: I Compaq rack I Standard 19-in EIA/RETMA rack I StorageWorks metric rack NOTE: RETMA and StorageWorks racks require a MiniLibrary table-top-to-rackmount kit, metric/RETMA (Part Number 120882-B21). Contact your Compaq sales representative for more information. This section describes how to separate the rail slides, followed by the rackmount instructions. Follow the directions in the shipping container to unpack the module(s). Save the packing materials for re-use in case you need to return the module(s) for repairs. The inner slide is attached to the module by means of three screws. Remove the packing tape from the slides, and separate each set of slides as described in the following section.