HP SW TL881 DLT Mini-Lib/1 Compaq StorageWorks TL881/TL891 Family MiniLibrary - Page 153

Diagnostics and Troubleshooting 6-11 Table 6-5 Motor Process Error Codes (3xxx) continued FSC Message 300C Picker Open Tach 300D Door Open Tach 300E Drive Stow Error 300F Slave Init Error 3010 Picker Retries Exceeded 3011 Picker Retries Exceeded 3012 Picker Retries Exceeded 3013 Picker Retries Exceeded 3014 Picker Retries Exceeded 3020 Undefined Config 3021 Wrong Codebase 3040 Motor Firmware Error 3042 Motor Firmware Error 3100 Picker Jammed 3101 Picker Jammed 3102 Picker Jammed Description Open Tach detected on picker motor. Open Tach detected on door motor. A problem was encountered while trying to stow a cartridge to a drive. Couldn't close the door. Check the Pass-Through Mechanism (PTM) access plate removed at the rear of the MiniLibrary Base Module. While attempting to fetch a cartridge, the picker was not able to properly position itself within 16 attempts. While attempting to fetch a cartridge, the picker was not able to properly position itself within 16 attempts. While attempting to fetch a cartridge, the picker was not able to properly position itself within 16 attempts. While attempting to fetch a cartridge, the picker was not able to properly position itself within 16 attempts. While stowing to a drive, the initial push failed. An unsupported configuration was detected. An attempt was made to flash the incorrect firmware image into the MiniLibrary system. Press the Enter button to flash or the Escape button to cancel. An undefined picker position was specified. An undefined door position was specified. The picker stalled during an inventory. During a stow operation, the picker was not able to insert the cartridge into the bin. While stowing to a bin, the picker moved too far. This generally occurs if the arm slips in between two cartridges during the final push. continued