HP Surestore E Tape Library Model 6/60 HP SureStore E Tape Library Models 2/20 - Page 27
Rackmounting the Library, for HP Authorized, Personnel
View all HP Surestore E Tape Library Model 6/60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Getting Started WARNING TIP Library Installation Installing the Library into a Rack Rackmounting the Library (for HP Authorized Personnel) Before you begin, lower the rack's leveler feet, and extend the rack's anti-tip foot. Failure to extend the anti-tip foot could result in personal injury or damage to the tape library if the rack tips over. To use the display panel and access the tape doors, mount the top of the library in the middle of the rack or 120 cm (48 in) above the floor. 1. Use the template for your model library as a guide, and install five clip nuts into each front column of the rack (Figure 1-3, Figure 1-4, or Figure 1-5, depending on your library model). In Figure 1-4 and Figure 1-5, the grey clip nuts indicate the position of the trim brackets (see step 7). The upper grey clip nuts are used for racks with a 55 mm bezel depth. The lower grey clip nuts are used for flushmount racks. Use the template as a guide, and install four clip nuts into each back column of the rack. Chapter 1 1-11