HP T610 HP Designjet T610 Series - User's Guide - Page 40
Load a roll into the 24-inch printer
UPC - 883585044344
View all HP T610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
4. If the roll is long; rest the spindle horizontally on a table and load the roll on the table. TIP: You may need two people to handle a large roll. 5. Slide the new roll onto the spindle. Make sure the paper type is oriented as shown. If it is not, remove the roll, turn it 180 degrees and slide it back on to the spindle. There are labels on the spindle showing the correct orientation. NOTE: From the back of the printer, the blue stopper is inserted into the right-side holder. Ensure both ends of the roll are as close to the spindle stops as possible. 6. Put the blue paper stop on to the open end of the spindle, and push it towards the end of the roll. Paper handling 7. Ensure the blue paper stop is pushed in as far as it goes; until both ends are against the stoppers. If you are a regular user of different paper types, you can change rolls more quickly if you preload rolls of different paper types on different spindles. Extra spindles are available for purchase, see Accessories on page 107. Load a roll into the 24-inch printer There are two ways to load a roll. The easy loading procedure is recommended. CAUTION: To start these procedures you must have a roll loaded on the spindle. See Load a roll onto the 24-inch spindle on page 26. 30 Chapter 5 Paper handling ENWW