HP Tc2120 serhp server tc2120 operations and maintenance guide - english - Page 61
Heading2 - POST Error Messages, System Board Jumper/Dip Switch Settings, ter 3, Connect
UPC - 808736945332
View all HP Tc2120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Chapter 4 Diagnostics POST Error Messages If you get a POST text error message in reverse video, details of the error are provided on the screen. Recommendations for troubleshooting are sometimes displayed along with the error message or by pressing Enter. Table 4-1 describes typical POST text errors and the corrective action you may take to remedy the problem. NOTE HP recommends you correct the error before proceeding, even if the server appears to start successfully. Table 4-1. POST Error Messages Message Error!! Flash protection switch is On Keyboard error or no keyboard present Keyboard is locked out - Unlock the key Mouse error or no mouse present Your computer case has been opened Message Corrective Action This indicates that configuration switch 2 is currently set to On. If you want to update the BIOS, do the following: 1. Power down the server. 2. Set configuration switch 2 to the Off position. Refer to "System Board Jumper/Dip Switch Settings" in Chapter 3. 1. Verify the keyboard connector is firmly seated and connected to the proper connector. Refer to "Connecting Peripheral Devices" in Chapter 3. 2. Reboot the server. 3. If the error persists, replace the keyboard with a known good keyboard and repeat steps 1 and 2. 4. If the error persists, try using a USB keyboard. The BIOS detects that the keyboard is locked. 1. Try to identify which keyboard key is locked and unlock the key. Reboot the server. 2. Try replacing the keyboard with a known good keyboard. Reboot the server. 3. Try using a USB keyboard. Reboot the server. 1. Verify the mouse connector is firmly seated and connected to the proper connector. Refer to "Connecting Peripheral Devices" in Chapter 3. 2. Reboot the server. 3. If the error persists, replace the mouse with a known good mouse and repeat steps 1 and 2. 4. If the error persists, try using a USB mouse. The BIOS reports that the chassis cover has been opened. This is a warning message. To avoid seeing this message again, do the following: 1. Make sure that the chassis cover is securely closed. 2. Reboot the system and press F10 during POST to enter the BIOS Setup. 3. When the "Message Confirmation" window appears, press Enter. 4. Press F6 to save and exit. Corrective Action 55