HP Xw8400 HP xw8400 Workstation - Service and Technical Reference Guide - Page 75
Removing memory module, CAUTION,
UPC - 883585271085
View all HP Xw8400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Removing memory module 1. Disconnect power from the system ( Pre-disassembly procedures on page 50), and remove the access panel (Access panel on page 57). Place the workstation on its side with the system board facing up. CAUTION: To ensure that memory modules are not damaged during removal or installation, power off the workstation and unplug the power cord from the AC power outlet. Wait until the LED on the back of the power supply turns off before removing memory. If you do not unplug the power cord while installing memory, your memory modules might be damaged and the system will not recognize the memory changes. 2. Press the green tab at the base of the memory fan (1) and lift it up (2) to expose the memory modules. Figure 4-15 Rotating the memory fan 3. Gently push out on the socket levers. ENWW Removing and replacing components 65