IBM 4560SLX User Guide - Page 77
Appendix A. Adding a tape drive
UPC - 087944855910
View all IBM 4560SLX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
Appendix A. Adding a tape drive This appendix explains how to add a tape drive to the library. See Chapter 1, "Introduction" for a list of tape drives supported by the library. To add a tape drive, complete the following procedure: 1. Unpack the tape drive and inspect it for any damage. If the tape drive has been damaged, return it to IBM for a replacement. Note: With a blank panel or tape drive removed, there is access to moving parts. DO NOT reach into open cavities. 2. Remove the blank panel that covers the appropriate tape-drive mounting bay as shown in Figure 62. Save the blank panel for future use. Figure 62. Removing tape-drive blank panel 3. Carefully insert the tape drive into the mounting bay. Make sure you push the drive in all the way so that it fully seats the mating connectors at the rear of the library. Note: The tape drives are hot-plug capable so you do not have to turn the library off when removing or installing a tape drive. © Copyright IBM Corp. 2002 67