IBM 4560SLX User Guide - Page 85
Cartridge elevator extension assembly, Components, Drive belt
UPC - 087944855910
View all IBM 4560SLX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Figure 68. Cartridge elevator (two units) installed 11. Replace drive 2 or the blank cover to all modules. If replacing a drive, repeat the procedure below for each module. a. Fully support the drive shoe assembly while starting it into the receiver, being careful not to damage the drive load handle. b. Push the drive shoe assembly slowly into the receiver until it seats against the back of the library. c. Tighten the two captive retainer screws to secure the module to the library. d. Repeat for all modules. See "Module configuration" on page 82. Cartridge elevator extension assembly This section provides information on cartridge elevator extension components and assembly. Components The cartridge elevator is made up of the following components: v Primary chassis (10U length) v Media elevator car v PCB v Belt block and brackets v Drive belt v Drive motor v Drive motor pulley v Belt tensioner ramp and idler pulley v Standoff v Motor cable The cartridge elevator extension contains the following components: v 5U extension Appendix B. Adding a library module 75