Icom IC-7200 Instruction Manual - Page 14
■ Rear Panel, Ci-v Remote Control Jack [remote] - software
View all Icom IC-7200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
1 PANEL DESCRIPTION ■ Rear panel o !0 !1 q REMOTE EXT SP w e r TUNER GND DC 13.8V ACC KEY SEND ALC ANT i uyt q USB JACK [ ] Connects an USB cable to be used for the modula- tion input (p. 20), the transceiver operation with PC and the received audio import to the PC. CAUTION: For Windows® XP/2000: NEVER install the driver before connecting an USB cable between the transceiver and PC. For Windows Vista™: NEVER connect an USB cable until the driver installation has been complete. About the USB driver: Icom HP (http://www.icom.co.jp/world/support/ index.html) gives the USB driver and the installation guide download service. The following items are required: PC • Microsoft® Windows® XP/2000 or Microsoft® Windows Vista™ installed • With USB port Other items • USB cable (third party's) • PC software About the modulation input: Select "U" (USB) in the set mode item 'Modulation input (Data OFF)' or 'Modulation input (Data ON)'. And the modulation input level from USB jack can be set in the set mode item 'USB Level.' (p. 77) w E XTERNAL SPEAKER JACK [EXT SP] (pgs. 14, 93) Connects a 4-8 ø external speaker, if desired. • When an external speaker is connected, the internal speaker does not function. e CI-V REMOTE CONTROL JACK [REMOTE] (pgs. 14, 88) ➥ Designed for use with a PC for remote control of the transceiver functions. ➥ Used for transceiver operation with another Icom CI-V transceiver or receiver. r ANTENNA CONNECTOR [ANT] (p. 13) Accepts a 50 Ω antenna with a PL-259 connector and a 50 Ω coaxial cable. t ALC INPUT JACK [ALC] (p. 17) Connects to the ALC output jack of a non-Icom lin- ear amplifier. y SEND CONTROL JACK [SEND] (p. 17) Goes to ground while transmitting to control exter- nal equipment such as a linear amplifier. • Max. control level: 16 V DC/0.5 A u ELECTRONIC KEYER JACK [KEY] Accepts a key or paddle connector for the internal electronic keyer. • The keyer type selection between the internal elec- tronic keyer and straight key operation can be made in set mode. When connecting (⊕) a straight key When connecting a paddle (dot) (com) (dash) If you use an external electronic keyer, make sure the output voltage of the keyer is less than 0.4 V when keying the transmitter.