Icom IC-7200 Instruction Manual - Page 39

4 RECEIVE AND TRANSMIT D Convenient functions for transmit • VOX (voice operated transmit) (p. 53) ➥ Push VOX to turn the VOX function ON or OFF. • " " appears when the VOX function is ON. ➥ Push and hold VOX for 1 sec. to enter the VOX set mode, then rotate [DIAL] to adjust the VOX gain, anti VOX gain or VOX delay. • Rotate [M-CH] to select an item. • Speech compressor (p. 57) ➥ Push COMP to turn the speech compressor ON or OFF. • " " appears when the speech compressor is ON. ➥ Push and hold COMP for 1 sec. to enter the com- pression level set mode, then rotate [DIAL] to ad- just the compression level. D About 5 MHz band operation (USA version only) 1 Operation on the 5 MHz band is allowed on 5 discrete frequencies and must adhere to the following: IC-7200 Display Frequency* FCC Channel Center Frequency* 2 • USB mode • Maximum of 50 watts ERP (Effective Radiated Power) 5.33050 MHz 5.34650 MHz 5.33200 MHz 5.34800 MHz 3 • 2.8 kHz bandwidth 5.36650 MHz 5.37150 MHz 5.36800 MHz 5.37300 MHz 4 It is the operator's responsibility to set all controls so that the transmission in this band meets the stringent 5.40350 MHz 5.40500 MHz 5 conditions under which we may use these frequen- *The channel center frequencies that are specified cies. by the FCC, show the center frequency of their 6 passband. However, the IC-7200 displays carrier NOTE: We recommend that you store these fre- point frequency, so set 1.5 kHz below from FCC 7 quencies, mode and filter settings into the mem- channel center frequency. ory channel for easy recall. 8 To assist you in operating the 5 MHz band cor- rectly within the rules specified by the FCC, 9 transmission is impossible on any 5 MHz band frequency other than the 5 frequencies indicated in 10 the table above. 11 12 13 14 15 16 17 18 19 20 21 34