Icom IC-7200 Instruction Manual - Page 67

7 MEMORY OPERATION ➔ ➔ ■ Memory programming Memory channel programming can be performed either in VFO mode or in memory mode. D Programming in VFO mode q Push V/M to select VFO mode. w Rotate [DIAL], and push MODE to set the de- sired frequency and operating mode. e R otate [M-CH] to select the desired memory channel. • If the RIT control indicator lights orange, push M-CH/RIT SET . (p. 61) • " " appears if the selected memory channel is a blank channel (one without any stored frequencies). RIT control indicator goes out Channel increases Channel decreases r P ush and hold MW for 1 sec. to program the displayed frequency and operating mode into the selected memory channel. • 3 beeps are emitted when memory programming is successful. [EXAMPLE]: Programming 7.088 MHz/LSB into ch 12. VFO mode Push Rotate [DIAL] Push Rotate [M-CH] Push and hold 7.088 MHz/LSB are programmed into ch 12. D Programming in memory mode q Push V/M to select memory mode. w R otate [M-CH] to select the desired memory channel. • If the RIT control indicator lights orange, push M-CH/RIT SET . (p. 61) • Memory channel contents appear in the display. RIT control indicator goes out Channel increases [EXAMPLE]: Programming 21.280 MHz/USB into ch 18. Memory mode Push Rotate [M-CH] Channel decreases e Rotate [DIAL], and push MODE to set the desired frequency and operating mode. • To program a blank channel, use direct frequency entry with the keypad. (p. 25) r Push and hold MW for 1 sec. to program the displayed frequency and operating mode into the memory channel. • 3 beeps are emitted when memory programming is successful. Rotate [DIAL] Push Push and hold 21.280 MHz/USB are programmed into ch 18. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 62