Icom IC-7200 Instruction Manual - Page 97

15 SPECIFICATIONS ■ General • Frequency coverage : Receive 30 kHz - 60.000000 MHz*1*2 Transmit 1.800 -1.999999 MHz*2, 3.500 - 3.999999 MHz*2 5.33050*3, 5.34650*3, 5.36650*3, 5.37150*3, 5.40350*3, 7.000 -7.300 MHz*2, 10.100 -10.150 MHz, 14.000 -14.350 MHz, 18.068 -18.168 MHz, 21.000 - 21.450 MHz, 24.890 - 24.990 MHz, 28.000 - 29.700 MHz, 50.000 -54.000 MHz*2, *1Some frequency bands are not guaranteed. *2Depending on version. *3USA version only. • Mode : SSB, CW, RTTY, AM • Number of memory CH : 2 01 (split memory: 199; scan edges: 2) channels • Antenna connector : SO-239 • Antenna impedance : 50 ø (unbalanced) • Usable temperature : -10°C to +60°C (+14°F to +140°F) range • Frequency stability : L ess than ± 0.5 ppm • Power supply : 13.8 V DC±15% (negative ground) requirement • Current drain : Transmit (at 100 W) 22 A (at 13.8 V DC) Receive squelched 1.3 A max. audio 2.0 A • Dimensions : 241(W) × 84(H) × 281(D) mm, (projections not included) 91⁄2(W) × 35⁄16(H) × 111⁄16(D) in • Weight (approx.) : 5.5 kg (12.1 lb) • CI-V connector : 2-conductor 3.5 (d) mm (1⁄8˝) • ACC connector : 13-pin ■ Transmitter • Output power SSB, CW, RTTY : 2-100 W AM : 1-25 W* (*Carrier power) • Modulation system SSB : Digital PSN modulation AM : Digital Low power modulation • Spurious emissions HF bands : Less than - 50 dB 50 MHz band : Less than - 63 dB • Carrier suppression : More than 50 dB • Unwanted sideband : More than 50 dB • Microphone : 8-pin connector (600 ø) connector • KEY connector : 3-conductor 6.3 (d) mm (1⁄4˝) ■ Receiver • Receive system : Triple-conversion superheterodyne • Intermediate frequencies 1st : 64.455 MHz 2nd : 455 kHz 3rd : 15.625 kHz • Sensitivity (10dB S/N, preamp: ON, Filter shape: sharp) SSB, CW : L ess than 0.16 µV (1.8−29.7 MHz) L ess than 0.13 µV (50 MHz band) AM : Less than 13 µV (0.5−1.799 MHz) L ess than 2 µV (1.8−29.7 MHz) Less than 1 µV (50 MHz band) • Squelch sensitivity (SSB, threshold, preamp ON) : Less than 5.6 µV • Selectivity SSB* (BW=2.4 kHz) : M ore than 2.4 kHz/-6 dB Less than 3.6 kHz/-60 dB CW* (BW=500 Hz) : More than 500 Hz/-6 dB Less than 900 Hz/-60 dB RTTY (BW=350 Hz) : More than 360 Hz/-6 dB Less than 650 Hz/-60 dB AM (BW=6 kHz) : M ore than 6.0 kHz/-6 dB Less than 15.0 kHz/-60 dB *IF filter shape is set to SHARP. • Spurious and image rejection ratio : M ore than 70 dB (except 1⁄2 IF through on 50 MHz band) • Audio output power : M ore than 2.0 W at 10% distortion with an 8 ø load (at 13.8 V DC) • RIT variable range • PHONES connector • EXT SP connector : ±9.999 kHz : 3-conductor 6.3 (d) mm (1⁄4˝)/8 ø : 2-conductor 3.5 (d) mm (1⁄8˝)/8 ø 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 92