Icom IC-7200 Instruction Manual - Page 40

4 RECEIVE AND TRANSMIT ■ Operating CW q C onnect a paddle, straight key or external elec- tronic keyer as on page 18. w P ush and hold F-INP ENT BAND for 1 sec., then push a band key to select the desired band. e P ush MODE to select CW mode. • After CW mode is selected, push and hold MODE for 1 sec. to toggle between CW and CW-R modes. r R otate [DIAL] to tune in a desired signal with the desired tone frequency. • The S-meter indicates received signal strength when signal is received. t R otate the [AF] control to set audio to a comfort- able listening level. y S et CW break-in operation and the CW delay time in the set mode. (p. 80) q P ush and hold M-CH/RIT SET for 1 sec. twice to enter the set mode. w R otate [M-CH] to select "BK-IN" to set the CW break-in operation. e R otate [DIAL] to select the CW break-in opera- tion from full break-in, semi break-in or OFF. • FL : full break-in • SE : semi break-in • OF : break-in OFF r R otate [M-CH] to select "BK-DELAY" to select the CW delay time when semi break-in operation is selected in step e. t R otate [DIAL] to set the desired delay time. y C ontinue to set the keyer settings in the set mode, if necessary. (pgs. 80, 81) u P ush M-CH/RIT SET to exit the set mode and return to normal operation. u K eying to transmit, use the paddle, straight key or external electronic keyer to send your CW signals. • " " appears. • The Po meter indicates the transmit power strength. i Stop keying to return to receive. MODE TS TUNER FILTER SPCH [AF] [DIAL] Band keys NB NR ANF METER V/M 1 1.8 A=/B 2 3.5 SPLIT 3 7 MW 4 10 M-CL 5 14 AGC 6 18 COMP271 RIT . GENE SCAN 8 24 MNF 0 50 VOX 9 28 F-INP ENT BAND P.AMP ATT M-CH/RIT SET [M-CH] "CW" or "CW-R" appears. Appears when semi break-in is selected. Appears while transmitting. 35