Icom IP100H Instruction Manual ver. 2.30 - Page 120
SYSLOG Host IP Address, the CS-IP100H*.
View all Icom IP100H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
4 ABOUT THE SETTING SCREEN 8. [Transceiver Settings] Menu ■ Transceiver Settings [Transceiver Settings]-[Transceiver Settings] P Q R S T U V W X Z (This is only an example.) T Firmware Server U SYSLOG Host IP Address V SYSLOG Severity W Read/Write Password �� X
4
ABOUT THE SETTING SCREEN
4-66
8. [Transceiver Settings] Menu
[Transceiver Settings]–[Transceiver Settings]
■
Transceiver Settings
(This is only an example.)
P
Q
R
S
T
U
V
W
X
Z
T
Firmware Server�����
Enter the IP Address or Host name of the Firmware Server for the
IP100H, up to 63 characters.
L
When the IP1000C is used as its Firmware Server, this entry is not
necessary.
L
Do not install the multiple firmware servers in the system.
U
SYSLOG Host IP Address
Enter the SYSLOG host’s address.
L
The host device must have the SYSLOG server function.
V
SYSLOG Severity ����
Select the log information to send to the SYSLOG host.
(Default:
M
DEBUG
M
INFO
M
NOTICE)
L
Enter a check mark to send the log entries.
W
Read/Write Password ��
Enter a password of up to 16 characters. The password is used when
reading from or writing to the IP100H, or updating the firmware using
the CS-IP100H*.
*
CS-IP100H is the cloning sofware for IP100H, and can be downloaded from
the Icom website.
X
<Apply> ��������
Click to apply the entries.
Z
<Reset> ��������
Click to restore the settings.
L
You cannot restore after clicking <Apply>.