Icom IP100H Instruction Manual ver. 2.30 - Page 86

4 ABOUT THE SETTING SCREEN 8. [Transceiver Settings] Menu [Transceiver Settings]-[Transceiver Management] ■■Transceiver Management The IP1000C can monitor the registered IP100Hs and IP100FSs. And if necessary, the IP1000C can reboot the registered IP100Hs at the same time. 7 1 2 3 4 5 6 8 9 10 (This is only an example.) LLAn IP100H is displayed in bold when the setting is changed and the reboot is required. 1 Selection Box Click a selection box to add a check mark for the IP100H to reboot. LLYou cannot select the IP100FS, or the IP100H that "Disconnected" in the [Registration Status] is displayed. LLBy clicking the [All] Box, you can select or cancel all IP100Hs in the list. 2 Registration Status ��� Displays the IP100Hs' or IP100FSs' Registration Status either the "Connected" or "Disconnected." LLIf the IP100H is turned OFF or IP100FS's application is not running, displays "Disconnected." LLWhen the IP1000C sends the reboot command to the IP100H from the [Transceiver Management] menu, the following status are displayed: "Receiving reboot command," "Reboot command reception success," "Reboot command reception failed," "Ready to reboot" "Rebooting," "Updating," "Update failed," "Downloading," "Status notification failed," and "Low battery." 3 IP Address Displays the IP Addresses of the IP100Hs or IP100FSs. LLWhile the "Registration Status" displays "Disconnected," "-" is displayed. 4 Current Status Displays the Current Status of the IP100Hs. (Example: In the meeting) LL Informatio ••If the Status function is set to OFF, "-" is displayed. ••If you click the button (7), the latest status will be displayed. ••When the IP100H is remotely locked by the IP100FS, and it cannot communicate with others or cannot transmit, "Transmit and receive disabled" or "Transmit disabled" is displayed. ••If the IP100H is sending an emergency call, "Emergency" is displayed. 4-32