Icom IP100H Instruction Manual ver. 2.30 - Page 88

4 ABOUT THE SETTING SCREEN 8. [Transceiver Settings] Menu ■■Transceiver Settings Registers or edits the IP100H or IP100FS settings. LLAfter the setting is completed, you must reboot the IP100H. [Transceiver Settings]-[Transceiver Registration] 1 2 3 4 5 6 7 8 (This is only an example.) 1 TRX No 2 Transceiver Model 3 Name 4 Unit ID 5 Password 6 Transceiver Port Number 9 10 Selects the number that the IP100H or IP100FS is registered to. Up to 100 terminals can be registered. LLDepending on the IP1000C versions, up to 20 terminals can be registered. Select either the IP100H or IP100FS. (Default: IP100H) Enter the transceiver name. (Up to 31 characters) Enter the Individual number (00001 ~ 60000).  (Default: 00001) Enter the password to access to the IP1000C. (Default: iptrx) LLUp to 12 characters, lower or upper letters, numbers, symbols can be used. Enter the port number that the IP100H uses to communicate with the IP1000C. (UDP port) LL Informatio ••The set port number (RTP) and the port number +1 (RTCP) are used for the communication. ••We recommend to use default port number, if it is not problem. ••The default number differs, depending on the [TRX No.] as shown below. (Default: TRX No. 1 (30000), TRX No. 2 (30002), TRX No. 3 (30004), TRX No. 4 (30006 TRX No. 100 (30198)) ••Setting range: Even numbers between 2 and 59998. (Some numbers may not be acceptable.) ••Do not set the port number which has already been used by another connection setting. ••When the "Transceiver Model" item (2) is selected "IP100FS," this item is not displayed. 4-34