Intermec PM23c PM23c, PM43, and PM43c Mid-Range Printer User Manual - Page 152
Setting, Description, Default, If Media Calibration Mode is set to Slow
View all Intermec PM23c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
Appendix B - Default Settings Media Settings (Continued) Setting Description Default Clip Default Start Adjust Stop Adjust Media Calibration Mode Length (Slow Mode) LTS Sensitivity Level Determines if the printer prints items Off outside the printable area of the label. When this is set to Off, the printer returns an error if any part of a bar code label cannot be printed because that part extends beyond the printable area. When this is set to On, the printer prints all bar code labels, but may also print unreadable, incomplete labels. Sets the length of media the printer feeds 0 (positive value) or retracts (negative value) before printing a label. Unit of measurement is defined in the Unit of Measure parameter. Range is -9999 to +9999. Sets the length of media the printer feeds 0 (positive value) or retracts (negative value) after printing a label. Unit of measurement is defined in the Unit of Measure parameter. Range is -9999 to +9999. Selects the mode the printer uses to Fast calibrate media. Use Slow if the printer has trouble identifying gaps or marks in media. If Media Calibration Mode is set to Slow, 0 the printer prints the media length plus 10 mm. This value sets an additional amount of media to be printed. Unit of measurement is defined in the Unit of Measurement parameter. Range is 0 to 3200. Sets the sensitivity of the label taken sensor. 0 Range is 0 to 14. Supported when the Cutter or Label Dispenser accessories are installed. 138 PM23c, PM43, and PM43c Mid-Range Printer User Manual