Intermec PM23c PM23c, PM43, and PM43c Mid-Range Printer User Manual - Page 47
Load Media for Cut-Off Printing, Caution: You must not use the cutter to cut through any kind
View all Intermec PM23c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Chapter 2 - Set Up the Printer Caution: You must not use the cutter to cut through any kind of adhesive, or other soft material, that may stick to the cutting parts and render the cutter inoperable or even damage the electric motor. The cutter module includes the Label Taken Sensor. You can also install the optional cutter tray accessory, which holds up to 20 labels or tickets. After you load media, you need to configure the cutter and the feed adjust settings. You may need to adjust the recommended values slightly depending on your media type, supply method, and roll sizes, or because of individual differences between printers. Load Media for Cut-Off Printing Cut-off printing is supported by the PM43 and PM43c printers with the cutter installed. 1 Open the media cover. 2 Turn the printhead lift lever counterclockwise to raise the printhead. 3 Open the cutter door. PM23c, PM43, and PM43c Mid-Range Printer User Manual 33