Netgear AC2200 User Manual - Page 139
Test the path from your computer to a remote device
View all Netgear AC2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
Orbi WiFi System ping www.routerlogin.net 3. Click the OK button. You should see a message like this one: Pinging with 32 bytes of data If the path is working, you see this message: Reply from < IP address >: bytes=32 time=NN ms TTL=xxx If the path is not working, you see this message: Request timed out If the path is not functioning correctly, you might be experiencing one of the following problems: • Wrong physical connections For a wired connection, make sure that the numbered LAN port LED is lit for the port to which you are connected. Check that the appropriate LEDs are on for your network devices. If your router and computer are connected to a separate Ethernet switch, make sure that the link LEDs are lit for the switch ports that are connected to your computer and router. • Wrong network configuration Verify that the Ethernet card driver software and TCP/IP software are both installed and configured on your computer. Verify that the IP address for your router and your computer are correct and that the addresses are on the same subnet. Test the path from your computer to a remote device After verifying that the LAN path works correctly, test the path from your computer to a remote device. To test the path from your computer to a remote device: 1. From the Windows toolbar, click the Start button and select Run. 2. In the Windows Run window, type: ping -n 10 where is the IP address of a remote device such as your ISP DNS server. If the path is functioning correctly, messages display that are similar to those shown in Test the LAN path to your router on page 138. Troubleshooting 139 User Manual