Panasonic BL-WV10A BL-MS103A Owner's Manual (English) - Page 139
When The Remote Control Is Missing, Sequential Display Mode
View all Panasonic BL-WV10A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
14 When the Remote Control is Missing 14 When the Remote Control is Missing 14.1 Sequential Display Mode The BL-WV10A requires the remote control to operate. If you lose your remote control, contact your dealer to purchase a new one (part number PSWEWV10A). Even without a remote control, however, setting the mode switch to [SEQ. DISP.] will allow you to view sequentially the screens from registered cameras. 1. Set the BL-WV10A's mode switch to [SEQ. DISP.] and turn it on again. • After the launch screen, the Camera Monitoring Screen will appear. • At a fixed interval, the display will run through each of the registered camera screens. Note • Use of the remote control during Automatic Display mode will display the following and fail to work. m • Automatic Display mode is for display only; you will be unable to record. • All registered cameras, local and remote, will be displayed sequentially. If, however, a remote camera has been set to not save its password, its screen will be skipped and the next screen displayed. • If there is no connection with a camera, because it is turned off, etc., a message indicating that the camera could not be accessed with appear for between 5 and 10 seconds, after which the next camera's image will appear. [For assistance, please call: 1-800-272-7033] 139