Panasonic BL-WV10A BL-MS103A Owner's Manual (English) - Page 140
ERROR MESSAGES, Quick Setup Error Messages, Causes and Solutions
View all Panasonic BL-WV10A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
15 Error Messages 15 Error Messages Quick Setup Error Messages Error Message Camera setup error Confirm connections and try again This camera's firmware is out of date Update camera firmware Camera firmware is out of date Update camera firmware Network setup error Check default settings and router settings Causes and Solutions This error appears if at some point during Quick Setup, connection with the camera was lost, which prevents Quick Setup from completion. • Check all cables, press the FACTORY DEFAULT RESET button on the camera, and re-perform Quick Setup. This error appears when the firmware for a camera connected using Quick Setup is out of date. The camera will be registered as a remote camera, but that severely limits its functionality. • After upgrading the firmware, erase the camera from the Camera List and re-register it. This error appears when the firmware for a camera connected using Quick Setup is out of date. The camera will be registered as a remote camera, but that severely limits its functionality. • After upgrading the firmware, erase the camera from the Camera List and re-register it. Quick Setup cannot be performed if the subnet mask for the router is set to either 255.255.255.248 or 255.255.255.252. • Use a subnet mask setting of 255.255.255.0. If the router's subnet mask has any value other than 255.255.255.0, you will need to set each camera's starting address manually. • For the camera IP address in the Advanced Settings Screen, enter a network segment address identical to that of the router. 140