Panasonic BL-WV10A BL-MS103A Owner's Manual (English) - Page 142
Error Message, Causes and Solutions, This error appears when either the Image
View all Panasonic BL-WV10A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
15 Error Messages Error Message The timer could not be set because the recording start and end time are the same. Set a different start or end time. The timer could not be set because the recording time overlaps with another timer. Set a different start and/or end time. To use the sensor, first enter the Administrator user name and password on this camera's [User Info] screen. No camera name entered. The IP address and port are not set. There was a recording error. Causes and Solutions This error is displayed if the start and end times during Timer Recording Setup are identical. • There must be a difference of at least one minute between start and end times. This error is displayed during Timer Recording Setup if the day and time are identical to those of a previously set timer recording. • Reset using different specifications for the recording. This error appears if the ID and password required for sensor use for remote cameras are different than those of the administrator. • Enter the administrator name and password in the [User Info] screen. This error appears when either the Image Confirm or Register button is pressed before entering a camera name when newly registering remote cameras. • Enter a camera name. This error appears when either the Image Confirm or Register button is pressed before entering a camera address when newly registering remote cameras. • Enter a camera address. This error appears if for some reason, during standard recording, the signal from a camera is lost. • Make sure camera monitoring is possible, then try recording again. 142