Panasonic BL-WV10A BL-MS103A Owner's Manual (English) - Page 153

Issue Camera Quick Setup fails. [Setting wireless parameters...] appears. It's taking a lot of time to register the cameras. The image from network cameras is not visible. A signal from a wireless router is being received, even though you're not using one. 16 Troubleshooting the BL-WV10A Causes and Solutions Are you following the procedures shown in "Connecting a camera"? • If registration fails, re-initialize the camera, turn the BL-WV10A off and then on again, and re-perform Quick Setup. If you're using the BB-HGW700A, is an Ethernet cable connecting it to the BL-WV10A? If you're using the BB-HGW700A, are its camera settings accurate? In addition to the router, is there another Panasonic device serving as an access point? • Remove that access point from the network, and turn the BL-WV10A off and then on again. This message appears when another BL-WV10A is connected. It indicates that the connected devices will have the same wireless settings configured for them. Network layouts may require a camera re-start, in which case registration can take up to 3 minutes. During Quick Setup, the BL-WV10A, after obtaining network data from the router, will seek out an IP address not currently in use for its own fixed IP. In addition, there are fixed IP addresses for cameras on which Quick Setup was performed. If the same IP address is chosen after Quick Setup, this will cause network problems. • Either change the IP settings for one of the duplicate IP devices, change the network settings for the BL-WV10A and the camera(s), or re-perform Basic Setup after resetting the default settings for the BLWV10A and re-initializing the camera(s). This will happen when wireless information is received from connected devices besides the BBHGW700A which support Panasonic's Quick Setup protocol (including the BL-WV10A itself). [For assistance, please call: 1-800-272-7033] 153