Panasonic CS-E18SD3UAW service manual - Page 54
Electric Heater Control 2
![]() |
View all Panasonic CS-E18SD3UAW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
12.8 Electric Heater Control 2 During Error happened, air conditioning unit will stop operation, TIMER LED will blink and indoor vane closed. Electric heater can be switch ON when fulfill the starting condition as follow except 2 errors. o H14 (Indoor intake air temperature sensor abnormality) o H19 (Indoor fan motor mechanism lock) Starting condition When all condition (1+2+3+4) are fulfilled. 1 Operation ON 2 Indoor Heating mode 3 Error happened Except error H14 and H19 4 Temperature different control (°F) Temp difference (Remote controller setting - Intake air temperature) When air conditioning is switched ON Heater ON 3.6 Heater OFF 1.8 ON by Temp difference ≥ 3.6°F OFF by Temp difference 1.8°F Control content 1 Indoor unit will start operate when receive operation ON signal from remote controller. 2 Indoor fan speed i) For error H23 - Indoor heat exchange sensor 1 abnormality H24 - Indoor heat exchange sensor 2 abnormality H27 - Outdoor air temperature sensor abnormality H28 - Outdoor heat exchange sensor abnormality Me Fan (Fan speed higher than other error because the outdoor unit compressor will still run at preset frequency about 27Hz (H23, H24) and 40Hz (H27, H28) ii) Other errors minimum fan speed = Lo Fan 3 Once Electric heater switched ON, It will operate at least 3 minutes. 54
![](/manual_guide/products/panasonic-e9sd3ua-service-manual-80b38e9/54.png)