Pioneer AVIC-7200NEX Owner s Manual - Page 4
Precaution - installation manual
View all Pioneer AVIC-7200NEX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Precaution Notes on internal memory Before removing the vehicle battery If the battery is disconnected or discharged, the memory will be erased and must be reprogrammed. Some of the settings and recorded contents will not be reset. Data subject to erasure The information is erased by disconnecting the yellow lead from the battery (or removing the battery itself). Some of the settings and recorded contents will not be reset. Resetting the microprocessor CAUTION Pressing the RESET button resets settings and recorded contents to the factory settings. - Do not perform this operation when a device is connected to this product. - Some of the settings and recorded contents will not be reset. The microprocessor must be reset under the following conditions: Prior to using this product for the first time after installation. If this product fails to operate properly. If there appears to be problems with the operation of the system. If your vehicle position is shown on the map with a signifi- cant positioning error. 1 Turn the ignition switch OFF. 2 Press the RESET button with a pen tip or other pointed implement. Refer to Checking part names and functions on page 5 Settings and recorded contents are reset to the factory settings. About this manual This manual uses diagrams of actual screens to describe operations. However, the screens on some products may not match those shown in this manual depending on the model used. 4 Meanings of Symbols Used in This Manual X0000BT This indicates model name that are supported the described operations. This indicates to touch an appropriate soft key on the touch screen. HOLD This indicates to touch and hold an appropriate soft key on the touch screen. This indicates that there is a reference or supplementary for the key or screen. Use and care of the remote control Installing the battery Slide the tray on the back of the remote control out and insert the battery with the plus (+) and minus (-) poles aligned properly. When using for the first time, pull out the film protruding from the tray. WARNING Do not ingest the battery, Chemical Burn Hazard. This product, including the supplied remote control, contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just two hours and can lead to death. Keep new or used batteries out of the reach of children. If the battery is swallowed or placed inside any part of the body, consult a doctor immediately. If the battery compartment does not close securely, stop using the product and keep it away from children. Batteries (battery pack or batteries installed) must not be exposed to excessive heat such as sunshine, fire or the like. CAUTION Remove the battery if the remote control is not used for a month or longer. There is a danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type. Do not handle the battery with metallic tools. Do not store the battery with metallic objects. If the battery leaks, wipe the remote control completely clean and install a new battery. When disposing of used batteries, comply with governmental regulations or environmental public institutions' rules that apply in your country/area. "Perchlorate Material - special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate. (Applicable to California, U.S.A.)" Using the remote control Point the remote control in the direction of the front panel to operate. p The remote control may not function properly in direct sunlight. CAUTION Do not store the remote control in high temperatures or direct sunlight. Do not let the remote control fall onto the floor, where it may become jammed under the brake or gas pedal.