Pioneer AVIC-7200NEX Owner s Manual - Page 67
Displaying the open source, licenses, Checking sensor learning status, and driving status, Checking
View all Pioneer AVIC-7200NEX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
System settings Displaying the open source licenses You can check the open source licenses of the functions that this product is equipped with. 1 Display the "System" setting screen. Refer to Displaying the "System" setting screen on page 63 2 Touch [System Information]. 3 Touch [Firmware Information]. 4 Touch [License]. Updating firmware CAUTION The external storage device for updating must contain only the correct update file. Never turn this product off, eject the SD memory card or disconnect the USB storage device while the firmware is being updated. You can only update the firmware when the vehicle is stopped and the parking brake is engaged. 1 Download the firmware update files into your computer. 2 Connect a blank (formatted) storage device to your computer, and then locate the correct update file and copy it onto the storage device. 3 Set the external storage device to this product. Refer to Inserting and ejecting an SD memory card on page 7 Refer to Plugging and unplugging a USB storage device on page 7 4 Turn the source off. Refer to Selecting a source on page 9 5 Display the "System" setting screen. Refer to Displaying the "System" setting screen on page 63 6 Touch [System Information]. 7 Touch [Firmware Update]. 8 Touch [Continue] to display the data transfer mode. Follow the on-screen instructions to finish updating the firmware. p If an error message appears on the screen, touch the display and perform the above steps again. Checking sensor learning status and driving status You can check the sensor learning status, such as the degree of learning. You can also check the current sensor values and the total number of speed pulses. 1 Display the "System" setting screen. Refer to Displaying the "System" setting screen on page 63 2 Touch [System Information]. 3 Touch [3D Calibration Status]. Clearing the status You can delete the learned results stored in the sensor. 1 Display the "3D Calibration Status" screen. 2 Touch [Distance] or [Speed Pulse], and then touch [Yes]. 3 Touch [Learning] and then touch [Reset All]. p Touch [Reset All] to reset the sensor after changing the installation position or angle. p If you touch [Reset Distance], all learned results stored in "Distance" are cleared. Checking the connections of leads Check that the leads are properly connected between this product and vehicle. 1 Display the "System" setting screen. Refer to Displaying the "System" setting screen on page 63 2 Touch [System Information]. 3 Touch [Connection Status]. GPS Antenna Displays the connection status of the GPS antenna ("OK" or "NOK") and the reception sensitivity. p If reception is poor, please change the installation position of the GPS antenna. Positioning Status Displays the positioning status (3D positioning, 2D positioning, or no positioning), the number of satellites used for positioning (orange), and the number of satellites whose signal has been received (yellow). If signals from more than three satellites are received, the current location can be measured. Refer to Positioning technology on page 80 Installation Indicates whether the installation position of this product is correct or not. If installed correctly, "OK" appears. When this product is installed at an extreme angle exceeding the limitation of the installing angle, "NOK(Inst. Angle)" will be displayed. If the installation of this product is continually changed and it is not firmly fixed into place, "NOK(Vibration)" will be displayed. Speed Pulse The speed pulse value detected by this product is shown. Illumination Displays the status of headlights or small lamps of the vehicle. Back Signal When the shift lever is shifted to "R" (reverse position), the signal switches to "High" or "Low". The signal displayed will vary depending on the vehicle. iDataLink Displays the status of the optional iDatalink adapter. 67