Sharp AR-BC260 AR-BC260 Operation Manual Suite - Page 178

GENERAL PROGRAMS Saddle stitch position adjust This program is used to adjust the stapling position (folding position) when using the saddle stitch function of the optional saddle stitch finisher. The value can be adjusted in 0.1 mm increments within ±3.0 mm from the reference position for each paper size. Max. +3 mm Position adjusted to the plus direction Min. -3 mm Position adjusted to the minus direction 1 2 12 11 Reference position [AUTOMATIC SADDLE STITCH] checkmark The saddle stitch print function can normally be divided into the following three general steps. 1. The pages of the original are automatically reordered to allow saddle stitch binding (saddle stitch function). 2. The pages are folded at the center. 3. The paper is stapled at the center in two places (saddle stitch stapling). The [AUTOMATIC SADDLE STITCH] checkbox is selected by default. Selection of the checkbox assumes the use of the above saddle stitch printing function (three steps). Saddle stitch stapling exceptions Depending on the purpose of saddle stitch stapling, it may be necessary to perform saddle stitch stapling on printed matter that has already been bound by saddle stitching. In this case, it is necessary to disable step 1 above. If you frequently perform this type of exceptional saddle stitch stapling that requires disabling step 1, remove the checkmark from the [AUTOMATIC SADDLE STITCH] checkbox. Stream feeding mode This program is used to enable the stream feeding mode of the document feeder. When the stream feeding mode is enabled, additional originals which are set in the document feeder tray within 5 seconds after the previous original was fed will be fed and copied automatically. NOTE The stream feeding mode will not function when the covers mode has been selected. Auto paper selection setting Use this program to select the paper type* for which the automatic paper selection function operates. Selections are "Plain paper", "Plain paper and recycle paper", and "Recycle paper". * The paper type set for each paper tray in the paper tray settings of the user settings (page 2-11 of the "Operation manual (for general information and copier operation)"). Registration adjustment Use this program when the color of characters and lines in color printing is off. Registration adjustment can be performed in two ways: manually and automatically. Normally [AUTO ADJUSTMENT] should be used. G [AUTO ADJUSTMENT] Touch this key to have registration adjustment performed automatically. After touching this key, touch the [EXECUTE] key. A message appears when automatic registration adjustment is completed. Touch the [EXIT] key to exit. G [MANUAL ADJUSTMENT] Touch this key to perform registration adjustment manually. Use this key when you require a higher level of precision than can be obtained with [AUTO ADJUSTMENT]. See page 13 for the procedure for manual registration adjustment. 12