Sharp AR-BC260 AR-BC260 Operation Manual Suite - Page 60

SADDLE STITCH FINISHER Troubleshooting saddle stitch finisher problems Check the list below before calling for service. Problem Check Solution or cause Stapling position is not correct (including saddle stitch). Stapling position not set properly? Check the stapling position setting. (See pages 3-4, 3-13 and 3-14.) The saddle stitch Are any saddle stitch finisher covers open? Close all covers. (See page 3-10 and 3-11.) finisher does not Message indicating need to remove paper Remove all remaining paper from the stapler operate. from the stapler compiler displayed? compiler referring to step 4 on page 3-8. Message to displayed? check the staple unit Remove jammed staples. (See page 3-8.) Stapling cannot be performed (including saddle stitch). Message to add staples displayed? Different size paper included? Is the paper badly curled, preventing stapling? Replace the staple cartridge. (See page 3-7.) Check that a staple cartridge has been installed. (See page 3-7.) Stapling cannot be performed onto different size paper. Differences in paper quality and type may result in bad curling of output paper. Take the paper out of the tray or bypass tray, turn it around, and reload it so that the top and bottom edges are reversed. The punch hole positions are not correct*1 The punch function is not set to the correct punch positions. Check the allowed hole punch positions. (See page 3-5.) Message to check the punch module displayed? Dispose of punch scraps. (See page 3-9.) Cannot be punched.* Mixed paper sizes? Paper is badly curled and the output paper is not punched. Punching is not possible when different paper sizes are mixed together. Differences in paper quality and type may result in bad curling of output paper. Take the paper out of the tray or bypass tray, turn it around, and reload it so that the top and bottom edges are reversed. * When a hole punch module is installed 3-12