Sharp AR-BC260 AR-BC260 Operation Manual Suite - Page 42
Misfeed in the transport area, fusing area, and exit area
View all Sharp AR-BC260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
MISFEED REMOVAL Misfeed in the transport area, fusing area, and exit area Transport area 1 Open the upper side cover and check for a misfeed. Push the lever upward and gently open the cover. Fusing area 1 Open the duplex bypass/inverter unit. Grasp the finger hold and gently open the unit. NOTE If paper is loaded in the bypass tray, temporarily remove the paper and close the bypass tray before opening the side cover. Be careful not to tear the misfed paper during removal. 2 Remove the misfed paper as shown in the illustrations below. If paper is misfed in the transport area, turn roller rotating knob A in the direction of the arrow to remove the misfed paper. NOTE The misfeed may have occurred inside the machine. Check carefully and remove it. 2 Gently close the upper side cover. NOTE Even after clearing a misfeed, paper may remain inside the machine on the transfer belt where it is not visible. In this case, after visible misfeeds are removed, the paper on the transfer belt will be automatically moved to a position where it is visible and a misfeed will be indicated once again on the display. Clear the misfeed as explained in "Misfeed in the transfer unit" (step 3 on the right side of this page). For this reason, it may be necessary to perform the "Misfeed in the transfer unit" procedure twice. Exit area 1 Misfeed in the exit area Models with an exit tray attached to the duplex bypass/inverter unit: Gently remove the misfed paper as shown in the illustration, taking care not to tear the paper. Models without the duplex bypass/ inverter unit: Gently remove the misfed paper as shown in the illustration, taking care not to tear the paper. Upper exit tray: Gently remove the misfed paper as shown in the illustration, taking care not to tear the paper. 2-20 CAUTION The fusing unit is hot. Take care in removing paper. (Do not touch any metal parts.) If you do not find a misfeed, open the cover of the fusing unit and check for a misfeed inside the fusing unit. CAUTION The fusing unit is hot. Take care in removing paper. (Do not touch any metal parts.) 3 Misfeed in the transfer unit If paper is misfed on the transfer belt, remove it gently without touching the transfer belt. Do not pull out the transfer unit. CAUTION The transfer unit is hot. Take care in removing paper. (Do not touch any metal parts.) 4 Gently close the duplex bypass/inverter unit. After closing, confirm that the misfeed message has been cleared and the normal display appears. If the duplex bypass/ inverter unit is not installed, close the side cover in the same way.