Sharp AR-BC260 AR-BC260 Operation Manual Suite - Page 74

SETTING ORIGINALS I When using the reversing single pass feeder 1 Adjust the original guides to the size of the originals. I When using the document glass Open the document cover, place the original face down on the document glass, and then gently close the document cover. 2 Place the originals face up in the document feeder tray. Set the originals all the way into the feed slot. Do not exceed the maximum height line marked on the original guide. Original size detector NOTES G Do not place any objects under the original size detector, because they may damage it or the original size may not be detected properly. G If an original has been placed in the document feeder tray of the reversing single pass feeder, remove it. Otherwise the original in the document feeder tray will be scanned instead of the original on the document glass. [ How to place the original ] Place the original in the appropriate position shown below according to its size. ( Center the original on the centering scale.) Original scale Centering scale Original scale Centering scale 8½x11 or A4 11x17 or A3 8½x14 or B4 8½x11 R or A4 R 5½x8½ or A5 NOTE Original size detection function One of the four groups of standard original sizes shown below can be selected for detection by the original size detection function. The factory default setting is "INCH-1 (AB-1)". The setting can be changed using "ORIGINAL SIZE DETECTOR SETTING" in the key operator programs. (Page 11 of the key operator's guide.) Group Detectable original sizes Document feeder tray (for reversing single pass feeding) or document glass 1 INCH - 1 11" x 17", 8-1/2" x 14", 8-1/2" x 11", 8-1/2" x 11"R, 5-1/2" x 8-1/2"* 2 INCH - 2 11" x 17", 8-1/2" x 13", 8-1/2" x 11", 8-1/2" x 11"R, 5-1/2" x 8-1/2"* 3 AB - 1 A3, A4, A4R, A5, B4, B5, B5R 4 AB - 2 A3, A4, A4R, A5, B5, B5R, 8-1/2" x 13" * When the reversing single pass feeder is used, these sizes are only supported for one-sided originals. 4-6