Sharp AR-BC260 AR-BC260 Operation Manual Suite - Page 180

PROGRAMS FOR COPY MODE Return from copy mode timing After printing ends in copy mode, this program is used to set the amount of time until the mode is changed and printing begins of a job waiting in printer mode or fax mode. The amount of time can be set from 0 second to 60 seconds in increments of 1 second. List print This program is used to print lists of key operator programs. Lists of key operator programs for copier, fax, printer and network scanner features are available. Key operator code change This program is used to change the key operator code. The key operator must register a key operator code number and use the number to gain access to key operator programs. Only one key operator code number can be registered. The factory has registered "00000" as the code number to allow initial access to the programs. It is recommended that the key operator use the factory number for initial entry into the programs and then choose and enter another number by this program. Product key Use these programs to input data required to activate the following systems. E-mail alert and status This program cannot be used now. This program is reserved for future customer support through a network. Network scanner expansion kit This program must be used to activate the network scanner expansion kit. For the password to be entered, contact your dealer. Serial number Use this program to check the serial number of the machine. This is necessary to obtain product keys for "E-mail alert and status" and the Network scanner expansion kit. PROGRAMS FOR COPY MODE This chapter explains the key operator programs that are used for copy mode. Copy settings OTHER FUNCTION SETTINGS "Other function settings" consists of the following programs: GInitial status settings GExposure adjustment GRotation copy setting GAdd or change extra preset ratios GInitial margin shift setting GErase width adjustment GSetting a maximum number of copies GInitial color balance setting GAuto color calibration GB/W 600dpi scanning mode for document feeder Initial status settings The copier settings will be reset when the main switch is turned off, when the [CA] key is pressed, or when the auto clear interval has elapsed. Use this program to establish new initial settings or to return the initial settings to the factory default settings. Paper tray, exposure mode, copy ratio, duplex mode, and output mode default settings can be selected. NOTE Even if the default state of the two-sided function has been set to other than one-sided to one-sided copy mode using this program, in the event that the two-sided function of the optional duplex module/2 x 500 sheet paper drawer or the reversing single pass feeder has failed or has been prohibited* from use, the default state will revert to one-sided to onesided copy mode. * Disabling of document feeder (page 11) Disabling of duplex (page 11) Disabling of inverter (page 11) Disabling of optional paper drawer (page 11) 14