Sharp AR-BC260 AR-BC260 Operation Manual Suite - Page 182
Enable/disable Settings
View all Sharp AR-BC260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 182 highlights
PROGRAMS FOR COPY MODE After the [EXECUTE] key is touched and a test patch printed, a message appears asking you to begin automatic adjustment. Place the test patch on the document glass as shown below and touch the [EXECUTE] key. Black Yellow Magenta Cyan NOTE Lay approximately five sheets of copy paper that are the same size as the test patch on top of the set test patch, and gently close the document cover. When a message appears informing you that auto color calibration is completed, touch the [OK] key to end the procedure. NOTE Before executing this program, check to see if the registration adjustment is correct. If not, execute [AUTO ADJUSTMENT] in [Registration adjustment] on page 12. B/W 600dpi scanning mode for document feeder The resolution for copying in black and white from the reversing single pass feeder can be changed from 600 x 300 dpi to 600 x 600 dpi (high quality mode). When high quality mode is used, fine print and thin lines are reproduced with greater clarity, however, the scanning speed is slower. If you prefer a faster scanning speed, do not enable high quality mode. When high quality mode is not selected, the following conditions must be satisfied in order to scan at 600 x 300 dpi and attain the fastest speed. Conditions for fast job speed (all must be satisfied): • The copy ratio must be set to 100% • AUTO, TEXT, TEXT/PRTD.PHOTO, or TEXT/ PHOTO must be selected for the exposure, and neither "COPY OF COPY" nor "COLOR TONE ENHANCEMENT" are selected. • When using a special function, only the following special functions can be used with 600 x 300 dpi resolution: MARGIN SHIFT, ERASE, CENTERING, TRANSPARENCY INSERTS, COVERS, MIRROR IMAGE, EXTRA SIZE ENABLE/DISABLE SETTINGS "Enable/Disable settings" consists of the following programs: G Disabling deletion of job programs G Disabling of bypass-tray in duplex copy G Disabling of covers mode G Disabling of auto paper selection Disabling deletion of job programs This program is used to prevent stored programs from being replaced or deleted. When this program is set, storing of job programs is also disabled. Disabling of bypass-tray in duplex copy (Only when an optional duplex module/2 x 500 sheet paper drawer is installed) This program is used to disable the use of the bypass tray when making duplex copies. The bypass tray is sometimes used to feed heavy paper. Loading heavy paper in the duplex module/2 x 500 sheet paper drawer may cause a misfeed or failure. If heavy paper is frequently used, it is recommended that you enable this program. Disabling of covers mode This program is used to prevent selection of the COVERS mode. Disabling of auto paper selection This program is used to prevent automatic paper selection. When automatic paper selection is disabled, the copier will not automatically select a paper tray containing paper that matches the size of the original placed on the document glass or in the reversing single pass feeder. 16