Sony DCR PC101 Operating Instructions - Page 104
Audio dubbing, Adding an audio sound on a recorded tape
View all Sony DCR PC101 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
Audio dubbing Adding an audio sound on a recorded tape Choose a connection mentioned before, and connect audio equipment or microphone to your camcorder. Then follow the procedure below. (1) Insert your recorded tape into your camcorder. (2) Set the POWER switch to VCR. (3) Locate the recording start point. Press to start playing back. To pause playing back, press at the recording start point. You can fine adjust the recording start point by pressing / . (4) Press FN, then select PAGE3. (5) Press A DUB CTRL to display control buttons. (6) Press AUDIO DUB. The green X appears on the LCD screen. (7) Press on your camcorder and at the same time start playing back the audio you want to record. The new sound is recorded in stereo 2 (ST2) during playback. While recording new sound, the red appears on the LCD screen. (8) Press on your camcorder at the point where you want to stop recording. 5 PAGE1 PAGE2 PAGE3 EXIT VDASTPAD CPOLADYE AUDDUIOB REC CDTURBL CTRL A DUB CTRL RET. REC PAUSE ARUEDCIO SDTUABRT 4 FN To add new sound more precisely Press ZERO SET MEMORY at the point where you want to stop recording later in playback. Carry out step 3. Recording automatically stops at the point where ZERO SET MEMORY was pressed. 104