Sony DCR PC101 Operating Instructions - Page 86
Dubbing only desired scenes, Digital program editing on tapes
View all Sony DCR PC101 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
Dubbing only desired scenes - Digital program editing (on tapes) Step 2: Setting the VCR to operate with the A/V connecting cable To edit using the VCR, send the control signal by infrared rays to the remote sensor on the VCR. When you connect using the A/V connecting cable, follow the procedures below, (1) to (4), to send the control signal correctly. (1) Setting the IR SETUP code 1 Set the POWER switch to VCR on your camcorder. 2 Turn the power of the connected VCR on, then set the input selector to LINE. When you connect a video camera recorder, set its power switch to VCR/ VTR. 3 Press FN to display PAGE1. 4 Press MENU, then select VIDEO EDIT in , then press EXEC (p. 192). 5 Press r/R to select TAPE, then press EXEC. 6 Press EDIT SET. 7 Press r/R to select CONTROL, then press EXEC. 8 Press r/R to select IR, then press EXEC. 9 Press r/R to select IR SETUP, then press EXEC. 0 Press r/R to select the IR SETUP code of your VCR, then press EXEC. Check the code in "About the IR SETUP code" (p. 88). 86