Sony DCR PC101 Operating Instructions - Page 105
Audio dubbing, Monitoring the new recorded sound
View all Sony DCR PC101 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
Editing Audio dubbing Monitoring the new recorded sound (1) Play back the tape on which you added audio. (2) Select AUDIO MIX in in the menu settings, then press EXEC (p. 187). VCR SET H i F i SOUND AUD I O M I X A/VcDV OUTST1 EXIT ST2 r R EXEC RET. (3) Press r/R to adjust the balance between the original sound (ST1) and the new sound (ST2), then press EXEC. About five minutes after you disconnect the power source or remove the battery pack, the setting of AUDIO MIX returns to the original sound (ST1) only. The default setting is original sound only. Notes •New sound cannot be recorded on a tape already recorded in the 16-bit mode (32 kHz, 44.1 kHz or 48 kHz) (p. 190). •New sound cannot be recorded on a tape already recorded in the LP mode. •You cannot add audio with the DV Interface. •New sound cannot be recorded on blank portions of the tape. If the i.LINK cable (optional) is connected to your camcorder You cannot add new sound to a recorded tape. We recommend that you add new sound on a tape recorded with your camcorder If you add new sound on a tape recorded with another camcorder (including other DCR-PC101), the sound quality may become worse. If you set the write-protect tab of the tape to lock You cannot record on a tape. Slide the write-protect tab to release the write protection. 105