Sony LF-X11 User Manual - Page 17
Connecting the IR Blaster, See Configuring the On-Screen Remote - ir blaster to control
View all Sony LF-X11 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Preparations Connecting the IR Blaster Attach the supplied IR Blaster to the device connected to the Base Station. By attaching the IR Blaster, you can control the connected device with the on-screen remote control. When controlling two devices with the IR Blaster, position the devices and the IR Blaster as shown. IR Blaster Infrared receivers IR Blaster Infrared transmitter Infrared receiver To locate the infrared receiver, refer to the operating instructions for the connected device. Be sure to place the IR Blaster above the infrared receiver. Note Do not remove the backing paper from the IR Blaster yet. After confirming that the remote control works correctly, remove the backing paper from the rear side of the IR Blaster and then secure the IR Blaster in place. Note For details on setting up a device, refer to the operating instructions of the device. If the infrared receivers on two devices do not line up and cannot be controlled with the single supplied IR Blaster, you need to purchase a plug adapter (not supplied) and another IR Blaster. Connect the plug adapter to the IR BLASTER port on the Base Station and connect each IR Blaster to a port on the adapter plug. See "Configuring the On-Screen Remote" (1 page 67) for information about how to switch the on-screen remote for two devices to a single input terminal. z Tips • If the IR Blaster cable is too short, use the extension cable (RK-G138, not supplied). • Infrared receivers on Sony VCRs and other products are identified with the symbol. • You can set up 2 on-screen remote controls for each video input connector. These on-screen remote controls allow you to operate 2 devices connected directly to the Base Station, and to control video input via those devices. Backing paper 17