Sony PMW320K Product Manual (PMW320 Operating Instruction) - Page 146
Nonlinear Editing, Recording External Input Signals, HD & HDV or SD & HDV, SD & DV
View all Sony PMW320K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 146 highlights
Chapter 8 Connecting External Devices • Set OPERATION >Input/Output >Output & i.LINK in the setup menu (see page 98) to "HD & HDV" or "SD & HDV". HD & HDV or SD & HDV: To output an HDV stream in HD mode when the video format is set to an HDV compatible format (SP 1440/59.94i, SP 1440/50i, or SP 1440/23.94P) SD & DV: To output a DV stream • Set OPERATION >Input/Output >i.LINK I/O in the setup menu to [Enable]. • Set MAINTENANCE >Trigger Mode >i.LINK Trigger Mode in the setup menu (see page 126) to [Both] or [External]. Both: To perform recording both on the memory card in this camcorder and on the external device External: To perform recording only on the external device 2 Set the external device to recording standby status. For operations of the external device, refer to the operation manual of that device. 3 Start recording. The external device starts recording in synchronization. The status of the external device is displayed in the i.LINK status indication area (see page 31) on the viewfinder screen. Indication STBY HDV zREC HDV STBY DV zREC DV Status of the external device In HDV recording standby In HDV recording In DV recording standby In DV recording Notes • Operation may be different depending on the type of external device. • There is some time lag from which you start recording until the i.LINK status indication changes. Even if MAINTENANCE >Trigger Mode >i.LINK Trigger Mode is set to [Both], the connected i.LINK device does not start recording until it is in synchronization with this camcorder. • While you can record shot marks on the memory card during recording, they are not added to the pictures recorded on the external device. Nonlinear Editing You can transfer an HDV stream to a nonlinear editing system connected via the i.LINK (HDV/ DV) connector. Notes • The i.LINK (HDV/DV) connector of this camcorder is a 6-pin connector. Check the number of pins of the i.LINK connector on your computer and use an appropriate i.LINK cable. • In searching pictures of this camcorder on the computer, it may take some time until the display is reflected on the computer. • If the playback clip is short or the playback starting point is near the end of the clip, the i.LINK signal may be interrupted between the clip and the next clip. When you try to capture such a signal using the nonlinear editing system, a malfunction may occur, depending on the nonlinear editing software in use. • If you specify a search speed other than 4, 15, or 24 times normal with the nonlinear editing system, no i.LINK signal is fed out. In such a case, the picture on the LCD monitor may stay frozen. • High-speed playback picture may not be displayed on the computer screen, depending on the nonlinear editing software in use. Setting on this camcorder Set OPERATION >Input/Output >i.LINK I/O in the setup menu to [Enable]. For operations of the nonlinear editing software, refer to the operation manual of the software. Recording External Input Signals The HDV stream input from a device connected via the i.LINK (HDV/DV) connector can be recorded on an S×S memory card in this camcorder. The timecodes superimposed on the i.LINK input are recorded regardless of the settings of the camcorder. Note DV stream cannot be recorded. 1 Set the external signal to a format that can be recorded on the camcorder. Select an HDV compatible format (SP 1440/ 59.94i, SP 1440/50i, or SP 1440/23.94P) for the video format. 146 Connecting an External Device (i.LINK Connection)