Sony SRR1000 Product Brochure (SRMASTER: SRR1000 Operation Manual) - Page 47

Chapter 5 Menu Items Button ALT/[F8] [F1] Indication MONITOR SETTING DUAL [F2] BORDER [F3] BD LEVEL [F4] BD SLOPE [F5] BD POS [F10] ALT/ [F10] [F2] EXIT PORT CONFIG SCAN [F3] SIZE [F4] SIGNAL [F5] 2D/3D Setting Sets the settings for monitor output in 3D mode. Target Out Sets the monitor output for 3D mode. Out Link-AB: Outputs each of the LINK-A signal (the signal input from the HD SDI INPUT A connector) and LINK-B signal (the signal input from the HD SDI INPUT B connector) in the same way as with main output. Link-BA: Outputs with LINK-A and LINK-B interchanged in relation to the main output. Note When this item is set to any of the following, the same signal is output for LINK A output and LINK B output. Link-A: Outputs the LINK-A signal. Link-B: Outputs the LINK-B signal. Splt-AB: Splits the screen into two and outputs the LINK-A signal to the left screen and the LINK-B signal to the right screen. Splt-BA: Splits the screen into two and outputs the LINK-B signal to the left screen and the LINK-A signal to the right screen. FSq-AB: Outputs the LINK-A signal to the 1st field and the LINK-B signal to the 2nd field. FSq-BA: Outputs the LINK-B signal to the 1st field and the LINK-A signal to the 2nd field. SxS-AB: Splits the screen into two and then reduces the width of the LINK-A signal by half and outputs it to left screen and reduces the width of the LINK-B signal by half and outputs it to the right half. SxS-BA: Splits the screen into two and then reduces the width of the LINK-B signal by half and outputs it to left screen and reduces the width of the LINK-A signal by half and outputs it to the right half. Selects whether to display a dividing line on the screen when the unit is set to split Out the screen into two and output the signals to the monitor during 3D mode. Off On Sets the brightness level of the dividing line on the screen when the unit is set to Out split the screen into two and output the signals to the monitor during 3D mode. 1 to 8 to 127 Selects whether the dividing line is sloped on the screen when the unit is set to split Out the screen into two and output the signals to the monitor during 3D mode. Off On Sets the position of the dividing line on the screen when the unit is set to split the Out screen into two and output the signals to the monitor during 3D mode. -480 to 0 to 480 Redisplays the previous menu. - Sets the input/output signals of the input/output ports. I/O Sets the scanning method. I/O Interlace PsF Progres Sets the resolution. I/O 1280 : 720 1920 : 1080 Sets the sampling rate of video signals. I/O YPbPr RGB Sets 2D/3D operation. I/O 2D 3D 47 Detailed Menu Description