Toshiba Tecra M2-S519 User Manual - Page 118

Power and Power-Up Modes When you format an SD Memory card, all data will be deleted. Be sure to save data on the card to other media before you format the card. ■ Disable (button) Click this button to invalidate the token. You cannot revalidate old tokens, but you can use the same SD cards to create new tokens. Supervisor password If you set a supervisor password, some functions might be restricted when a user logs on with the user password. To set a supervisor password, execute the file TOSUP.EXE. The file is located at: C:\Program Files\Toshiba\Windows Utilities\SVPWTool\TOSUP.EXE This utility lets you do the following: ■ Register, delete or change the supervisor password. ■ Create or invalidate a supervisor password token This function in the TOSHIBA Password Utility lets you invalidate only supervisor tokens or all tokens, including user and supervisor tokens. ■ Specify restrictions for general users. Starting the computer by password If you registered a password, there are two ways to start the computer: ■ Insert a token before you turn on the computer. The computer will start normally, without displaying a password prompt. ■ Enter the password manually. The password is necessary only if the computer was shut down in boot mode. It is not needed in Hibernation or Standby mode. To enter a password manually, follow these steps: 1. Turn on the power as described in Chapter 3, Getting Started. The following message will appear in the LCD: Password= 2. Enter the Password. 3. Press Enter. If you enter the password incorrectly three times in a row, the computer shuts off. In this case, you must turn the computer back on to retry password entry. TECRA M2 6-17