ZyXEL P-660H-T1 v2 User Guide - Page 172
Telnet Login
View all ZyXEL P-660H-T1 v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 172 highlights
Chapter 14 Remote Management Configuration Figure 89 Remote Management: Telnet The following table describes the labels in this screen. Table 63 Remote Management: Telnet LABEL DESCRIPTION Port You may change the server port number for a service if needed, however you must use the same port number in order to use that service for remote management. Access Status Select the interface(s) through which a computer may access the ZyXEL Device using this service. Secured Client IP A secured client is a "trusted" computer that is allowed to communicate with the ZyXEL Device using this service. Select All to allow any computer to access the ZyXEL Device using this service. Choose Selected to just allow the computer with the IP address that you specify to access the ZyXEL Device using this service. Apply Click Apply to save your customized settings and exit this screen. Cancel Click Cancel to begin configuring this screen afresh. 14.5 Telnet Login Use the following steps to Telnet into your ZyXEL Device's command interpreter. 1 If your computer is connected to the ZyXEL Device over the Internet, skip to the next step. Make sure your computer IP address and the ZyXEL Device IP address are on the same subnet. 2 In Windows, click Start (usually in the bottom left corner) and Run. Then type telnet and the ZyXEL Device's IP address. For example, enter telnet 192.168.1.1 (the default IP address). 3 Click OK. A login screen displays. Enter the password at the prompts. 4 Always type the full command. A list of valid commands can be found by typing help or ? at the command prompt. 5 Type exit to close the session when finished. 172 P-660H-Tx v2 User's Guide