Adaptec 2020ZCR Reference Guide - Page 104

container Commands /extend_fs{=boolean} Specifies whether to extend the file system so that it occupies the entire reconfigured array. If you specify TRUE, the command adds no new freespace and extends the file system so that it occupies the entire reconfigured array. (The command extends the file system after completing the reconfigure operation.) If you specify FALSE, the command adds freespace to the reconfigured array and does not extend the file system to occupy the entire reconfigured array. This switch defaults to FALSE. This switch applies only to those multilevel volume sets on which an NTFS file system resides. If you extend an NTFS file system, you must reboot your system in order for the extension to take effect. If you do not specify this switch, you can later extend the file system with the container extend file_system command. This switch is supported on Windows. /mirror{=boolean} Specifies whether to reconfigure the existing array into a mirror set. If you specify TRUE, the command reconfigures the existing array into a mirror set. If you specify FALSE, the command does not reconfigure the existing array into a mirror set. This switch defaults to FALSE. /partition_move{=boolean} Specifies whether to move partitions instead of adding extra space (using additional disks). If you specify TRUE, the command moves partitions instead of adding extra space. If you specify FALSE, the command does not move partitions. This switch defaults to FALSE. /partition_size{=integer} Specifies the partition size. All partitions must be the same size and you can specify only one partition per disk. 3-73